Specifications

Optional counterweight cartridge weight 5 – 10g
Pressure of cartridge 5 – 30mN
Drive belt
Motor synchronic AC
Gilt RCA, GND jack gold plating
Speed range 33,33 / 45,11 r.p.m.
Speed deviation +/- 0,5%
Speed flutter +/- 0,1%
Signal to noise ratio S/N -60dB
Spead change manual
The length of the active arm 40mm
Mass of the arm 30g
Tracking error 0
Anti-skating 0
Height Adjustment (VTA) + / – 10mm
Arm Height Adjustment range +/- 5
Platter Height Adjustment +/- 8mm
Platter weight/ diameter / height 3kg / 310 / 40
Dimensions 450 x 350 x 180
Weight 20kg
Power supply 110V-240V / 50Hz-0Hz
Power consumption 2W
Cartridge not included

The set includes:
Turntable with equipment
User manual
Warranty
Invoice
Transport box

About DE-1800NG

Tonearm:
A very low air pressure (0.030MPa) is needed for this turntable to work properly. The pressure is easily produced by a silent compressor, which is an inseparable part of the turntable.
The way the arm is operated on the air cushion is quite simple. Thanks to the pressure from the compressor, the arm bearing can detach and levitate in the air alongside the guide.
Due to the wide range of calibration options, the arm can support most MM /MC cartridges available on the market.

Motor:
A very quiet DC motor (12V) is used to drive the platter. The motor, which is located next to the acrylic platter, transmits the torque using two thin silicon belts.

The platter bearing consists of a sleeve made of bronze and a high-gloss polished axis. The whole platter is resting on two balls immersed in an oil bath. The bearing is made with such a high precision that an oil film is created between the two friction elements, further reducing friction and bearing noise.

It is possible to choose a magnetic platter bearing that is using very strong neodymium magnets.

The turntable can play discs recorded at 33 and 45 RPM. The control panel located on the side of the turntable changes speeds and fine-adjusts the rotation of the disc. As a standard, a high-quality power supply unit, located in the compressor, is coming with the turntable. This allows for the compressor to be controlled from the panel on the turntable.

About Pre Audio

We create a team of acousticians, we love what we do and we do what we love. The results are unique projects for our clients and finally device close to perfection.

Examples of models can be seen in the section products.
Our experience and projects allow us to create sets with the highest quality.
Since its inception we were supporters and faithful defenders of natural full-sound, top quality equipment, which can produce the sound.
Offered equipment puts us in first place in front of the musical stage, where you can relax and enjoy the excellent sound.

Linear Turntables
The tangencial arm moves linearly to keep the cardrige in a tangencial direction to the groove. The heads that are cutting the vynil record are also moving linearly, so the groove, that is the result of that cutting, is always perpendicular to the radius of the disc. Classic turntables have arms built on a rotating bearing. When the arm moves/rotates, it changes the relative position of the cardrige, according to the vynil disc. More important is the change in the angle between the direction of the cardrige and the direction of the groove. This way the needle that reads the written sound is set in the groove at a different angle than the stylus that was cutting the vinyl.